[Seafarer12]

Hey Guys,
I got a CH Auto Champion Mk 2 press. Does anyone still carry parts for them? I need the primer feed tube and some powder bushings. I am pretty sure I could rig something up with the primer feed and make some bushings if I had to but I would rather get the correct parts if I can.

[LHB1]

Try: http://www.ch4d.com/ 740-397-7214

Good shooting and be safe.
LB

[Jim Watson]

CH/4D will not directly support the Autochamps except with spare parts left on hand. But they have a powder measure that uses the same bushings and you can get those. Paul "Fitz" Jones, moderator for this group, was in the business and has a lot of parts and equipment. I would contact him, too.

[Seafarer12]

The owner got back to me and said they still made bushings and primer tubes that would work. I am just waiting to hear back from him with some more details.

[Seafarer12]

I was talking to a guy that was selling a bushing set and he mentioned to me he had a couple of spares he would give to me. One is a 3 grain red dot bushing and the other is a 12.5 2400 bushing. That is my 38 158 grain load and the 12.5 is just about my 180 grain 357 load. The next size up(that I can buy from CH for 4.50) will give me 14 grains of 2400 my 158 grain 357 load. This thing should be pretty sweet when I get it set up.