HELP Ruger 10/22 Barrel Removal


PDA






JDMAN65
October 7, 2008, 09:38 PM
:banghead:According to Serial number look up on ruger website it was manufactured in 1977... It is an all metal receiver. I have removed the 5/32 allen bolts and the block... can not get the barrel out... Any sugestions?

:cuss: :banghead:

If you enjoyed reading about "HELP Ruger 10/22 Barrel Removal" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Mr White
October 7, 2008, 09:56 PM
Put the barrel in a vise with wooden jaw inserts and twist the receiver. Maybe a shot of WD40 and a few taps with a brass mallet would help too.

CRITGIT
October 7, 2008, 09:57 PM
It's fairly common! Rotate back and forth. If that doesn't do it then heat it with a hair dryer. One's steel and the other is aluminum. It'll come!

CRITGIT

Jubjub
October 7, 2008, 11:58 PM
Just pull the bolt back and let it spring forward and whack the barrel. A few hits are almost always enough to start the barrel.

highorder
October 8, 2008, 12:34 AM
Just pull the bolt back and let it spring forward and whack the barrel. A few hits are almost always enough to start the barrel.

+1

My method exactly. Works every time.

texfed
October 8, 2008, 12:42 AM
Use Kroil It'll penetrate better than anything on the market.

If you enjoyed reading about "HELP Ruger 10/22 Barrel Removal" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!