[Hutch]

Guys, forgive me if this has been done to death elsewhere, but....

Does anyone make a replacement baseplate for a full-capacity Glock, Beretta (finally got one!!) or CZ mag that has a flashlight clamp or a place on which to clamp a "combat light"? I have seen aftermarket Glock mags (of diminished capacity:mad: ) that had a clamp for a mini-mag. Without any experience with those, I kinda like that spot, 'cause it doesn't require any holster mods.

Any comments, experiences or suggestions welcome.

[TechBrute]

I don't screw with the baseplates of glocks anymore due to an "incident" I had. I was executing a reload of my Glock 27 while being timed, and when I slammed the mag home the finger extension I had on it slid forward far enough to pop off. The spring and ammo went all over the ground and I was left with an empty mag body in my gun. I yanked it out and proceded, but it has caused me to shy away from the different mag plates on the polymer mags.

[AngryBassets]

I have one; it's polymer and it replaces the floor plate on my LE Glock 22 mag (that I use in my 23 for tac team ops). It fits a Streamlight Scorpion (mini mag--why bother....) perfectly. It's too small for a Surefire G2, however.

And I have no idea who makes it.

[WYO]

It sounds like you are looking for the TACM III, which you can find at http://www.tacm3.com/

It looks kinda goofy, but I carry a spare mag with the TACM III base plate, and put the SureFire from my belt into the clamp for a good friction fit whenever I do a building search. They make them for Glocks and Berettas.

[Hutch]

Thanks for the tip. That's what I was looking for....