[murp242]

Does anyone have any information on taking the bolt out of a Model 12 ?

[evbutler462]

I found this on another site. It may be of help to you:

close bolt all the way. go to front of magazine and push pin to other side. rotate. push pump slide forward. rotate barrel and magazine tube 90 degress. and pull off.

to get trigger assymbly off. remove screw and pop out

End of quote.

If this doesn't help. chime back in and we'll try something else.

[murp242]

Thanks.....Ill give that a try...

[Hollywood Marine]

After you have removed the trigger group, with the gun inverted and the barrel pointing away from you, look at the right side of the bolt (looking down into the receiver). You will note a small part on the right edge of the bolt with two squared ends. this can be manipulated with a small screwdriver, moving either the forward end in and the rear end outward (in relation to the receiver) or vice versa. Whichever way it is in the gun when you remove the trigger group, move it the other way. the bolt can then be removed by drawing it to the rear and lifting its' reaward end. Upon re-assembly, be sure to move this lever back to its' original position after re-installing the bolt.