S&W Sigma


PDA






Bullnettles
December 2, 2008, 11:50 PM
I have a .40 Sigma and am looking to remove one of the two trigger springs to lighten the pull. If anyone has done this, I'd appreciate instructions. Thanks in advance. Nice forum btw, glad a friend showed me.

If you enjoyed reading about "S&W Sigma" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
kle
December 3, 2008, 12:37 AM
http://smith-wessonforum.com/eve/forums/a/tpc/f/580103904/m/1031000282?r=5661052282 -- here's one that involves cutting springs and smoothing the sear surfaces. You could remove either of the doubled springs from the sear block to lighten the pull, too.

Apparently, though, S&W put both of those springs in there due to reliability problems with a single spring in earlier models.

I had a SW9VE for a while last year, and I didn't find the trigger that heavy. A little gritty, sure, but not too heavy.

skeptiq
December 3, 2008, 09:58 AM
The 'gritty' should smooth out after firing a couple hundred rounds through it. I just bought the 9mm version and after the first 100 rounds, it's already more smooth than out of the box. You can also get some snap caps and go to town!

ZO6Vettever
December 3, 2008, 10:20 AM
S&W say snap caps not necessary in any of their products except 22 cal.

kle
December 3, 2008, 10:33 AM
S&W say snap caps not necessary in any of their products except 22 cal.

Better safe than sorry, though.

Bullnettles
December 3, 2008, 10:27 PM
Thanks for all the replies. I've never broken this one all the way down, but it has been through around 500 rounds. I will admit it has gotten smoother, but I'm not the best keeping down the push and pull my finger does when shooting. My accuracy isn't terrible, but I know I'm a bit better on a cocked revolver. I'd like to close that gap a bit and this seems to be the trick. Thanks for the good information and quick replies.

If you enjoyed reading about "S&W Sigma" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!