Kimber .22 Conversion - Extractor disassembly help


PDA






brandnew
December 14, 2008, 11:39 PM
I've done as much research as I can but I'm still at a loss for directions on how to remove the external extractor and firing pin from the .22 Kimber slide.

I've tried over and over with the regular method of depressing the firing pin and sliding off the firing pin stop but the stop just won't budge.

Any suggestions?

If you enjoyed reading about "Kimber .22 Conversion - Extractor disassembly help" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
brandnew
December 16, 2008, 10:20 PM
Seriously, nobody knows or has any information for me?

artjs
December 17, 2008, 11:30 AM
Quick call to Kimber Customer Service and here you go.... I needed this also, so that prompted my call to them

Step 1:
Remove the Elevation screw from the rear sight. NOTE Hold down on the back of the sight to ease pressure on the screw and to hold the springs underneath in place.
http://i9.photobucket.com/albums/a77/artjs/Step1-RemoveElevationScrew.jpg

Step 2:
Lift the rear sight up, again, don't lose the springs! Here they are:
http://i9.photobucket.com/albums/a77/artjs/Step2-CarefulSprings.jpg

Step 3:
Push the firing pin in and pry up on the firing pin stop. Yup, that's my Glock Tool :neener:
http://i9.photobucket.com/albums/a77/artjs/Step3-RemoveStop.jpg

External Extractor I didn't ask about... sorry
Kimber's Customer Service Line: 914-964-0771 x350

Izaak Walton
December 17, 2008, 07:20 PM
I did not know that, thanks!

If you enjoyed reading about "Kimber .22 Conversion - Extractor disassembly help" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!