Problem with the safety on a new trigger...


PDA






Auburn1992
December 23, 2008, 10:55 PM
Ok, in my other thread I mentioned I gotta new Jewell Trigger for my XR-100.

It installed fine, but I needed to sand some things down. It looks as if the safety is not going to engage (mobe back all the way) unless I do !A LOT! of sanding around that area. The safety design is way different from the original trigger, and the bolt release is a little wider.

What should I do about the safety. I don't really want to spend 5 hours sanding it down to get it to work.


By chance, will this effect accuracy by anding the stock down near the trigger?


Thanks,

AU

If you enjoyed reading about "Problem with the safety on a new trigger..." here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
If you enjoyed reading about "Problem with the safety on a new trigger..." here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!