Ejector Timing on a Beretta 687EELL?

PDA






grits
January 4, 2009, 02:31 AM
Hello Everyone

I am fitting a set of barrels on a Beretta 687EELL. The extractors a slightly our of time. I think I know where I need to remove metal but I wanted an opinion from someone that has done it.

I am open to any and all suggestions.

Thanks,

Grits
If you enjoyed reading about "Ejector Timing on a Beretta 687EELL?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
JohnBT
January 4, 2009, 10:47 AM
I saw this ts.com thread and thought it might help. John

www.trapshooters.com/cfpages/thread.cfm?threadid=169542&Messages=7

According to GunDr's post,

"Removing material will cause the ejectors to trip sooner. It appears your is tripping to soon already, so removing any amount from the tail(s) will cause it to trip even faster.

I find it very odd that the ejector is tripping too soon with a brand new bbl. The ejector tails tend to be extra long for timing AFTER the CORRECT fitting of the bbl.

I also agree with Shooting Coach, Berettas are very finicky with the ejector timing. The wood really likes to influence them.

Doug Braker"
If you enjoyed reading about "Ejector Timing on a Beretta 687EELL?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!