Bending Glock trigger guard?

PDA






Dalerj
February 2, 2009, 09:04 AM
I am thinking about a glock 17. The problem is my trigger finger has a bend (sideways) in the second joint. This causes the tip of my finger to drag on the inside of the glock trigger guard. Would it be possible to bow out the bottom of the guard 1/4 inch using heat? What temp does the glock plastic get soft enough to bend? Thanks, Dalerj
If you enjoyed reading about "Bending Glock trigger guard?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
krs
February 2, 2009, 10:21 AM
Dunno, but there was a guy here with demos of stippling in the plastic done with a 35 watt soldering iron. At least I think he said it was 35 watts.
If you enjoyed reading about "Bending Glock trigger guard?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!