win 94 and williams peep sight problem


PDA






Zepo
March 9, 2009, 08:51 PM
Hey all,

Well i popped out the bull sight on my Winchester 94AE and put a marble 3/8 blank in there. so far so good. when I installed the peep sight which is the correct sight 5D-94se it seems I can't adjust it near its lowest setting without it scraping the breech bolt, any Ideas?

thanks Zepo

If you enjoyed reading about "win 94 and williams peep sight problem" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Onmilo
March 9, 2009, 09:01 PM
Yep.
Adjust the site to the lowest setting that doesn't interfere with the bolt, then unscrew the little screw on the settings plate and slide the plate to zero, tighten the screw.

Once you get your actual zero, in example, a 100 yard target zero, you can readjust the settings plate to reflect that setting as you actual zero setting. HTH

If you enjoyed reading about "win 94 and williams peep sight problem" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!