[1KPerDay]

Model 10

http://i12.photobucket.com/albums/a206/1KPerDay/Guns/0e6d68c5.jpg
http://i12.photobucket.com/albums/a206/1KPerDay/Guns/084d93da.jpg
http://i12.photobucket.com/albums/a206/1KPerDay/Guns/ce212883.jpg

Ajax sambar stag grips purchased from a THR member.

Before:

http://i12.photobucket.com/albums/a206/1KPerDay/Guns/c4269786.jpg


The grips are a little proud along the bottom and near the top of the backstrap... I assume you can sand these but are there any caveats?

[BHP FAN]

sweet! They really 'make' the gun!

[1KPerDay]

Thanks! Anyone know about sanding/fitting these?

[Cocked & Locked]

Thanks! Anyone know about sanding/fitting these?

Yes...easy task! Work them as wood. I'd mark the proud area (while on the S&W) with a pencil. Then remove the grips from the gun and start sanding a little at a time...trying them back on for fit as you go.

If you have a buffing wheel, Tripoli (brown) buffing compound will bring on the shine.

These were big time proud around the rear and bottom. I did them as described above and then installed the medallions.
http://pic90.picturetrail.com/VOL2169/3082611/6486421/328391449.jpg

[1KPerDay]

Very nice C&L! But then again all your stuff is. :D :cool: