Hornady Case Feeder is Saaaweeeeeet!


PDA






jmahalek
April 10, 2009, 06:56 PM
Hooked it up to the LNL AP and WOW! I can flat out reload now. No more messing with putting cases in station 1. Switching from .45acp to 9mm is no big deal (<5 minutes).

If you enjoyed reading about "Hornady Case Feeder is Saaaweeeeeet!" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
IMtheNRA
April 10, 2009, 09:32 PM
Congratulations! Graf shipped mine today!

How was your experience setting it up and dialing it in?:)

jmahalek
April 10, 2009, 10:09 PM
Not bad at all. Thought the manual wasn't half bad. The diagram in back that shows all the parts helps. Maybe photocopy it and have it available while following the instructions. Make sure you have some wrenches and allen wrenches available.

Also, I had to "remount" my press as I had it too far back from the edge of my bench. This keeps the cam wire from being able to drop down and adjust the timing of the v-block (pushes shell) and the shellplate. I think the case feeder manual recommends 2.25" from the edge of the bench.

bobotech
April 10, 2009, 11:18 PM
Its frickin' noisy though!!! That is my only beef with mine.

barbarian
April 11, 2009, 10:46 AM
Hooked it up to the LNL AP and WOW! I can flat out reload now. No more messing with putting cases in station 1. Switching from .45acp to 9mm is no big deal (<5 minutes).

+1 on case feeder

Barbarian

jmahalek
April 11, 2009, 10:55 AM
Mine is just not that noisy. Maybe i'm hard of hearing. Ehhhh?

1911user
April 11, 2009, 11:04 AM
With the case feeder, make sure the press is securely attached to the bench. It is a good idea to anchor the bench to the wall or maybe the floor.

If you enjoyed reading about "Hornady Case Feeder is Saaaweeeeeet!" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!