Liked my RAMI 9mm alloy a lot; but, I like my P-01 even more, even though the P-01 mag base plate of the factory 14 rounder is harder to hide.
My RAMI was very accurate and shot Hornady JHP/XTP (My SD ammo at the time) with out error. Never had a burp with any ball ammo.
My RAMI was never modified but I did replace the 10 rnd mag springs with 10% over strength. However, I don't think that I really needed to do this. Even the factory 14 rnd mag that I bought never failed to feed, I changed the springs just because that seemed to be the popular thing to do at the time. I believe the best things that I did to keep the RAMI working was a very thorough initial cleaning to remove the factory gunk and keeping it clean to include the mags. I kept the mags slick inside with a good dry lube.
April 22, 2009, 11:01 PM
I have a 2075 rami in 40 S&W. The only problem is finding holsters and accessories can be a bit of a challenge compared to a glock or springfield etc. I got my IWB holster from AKJ Concealco and it was well made and works well.
chris in va
April 22, 2009, 11:07 PM
I found the RAMI to be rather chunky and wide for the caliber it shoots, but just my opinion.
April 22, 2009, 11:25 PM
How's the trigger compared to a run-of-the-mill 75b?
April 23, 2009, 12:41 AM
Better trigger than the 3 stock 75Bs that I have owned.
My 26 round works great in the RAMI.
If you enjoyed reading about "Cz 2075 rami 9mm" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!