nikon prostaff 3-9 for pellet?


PDA






badbadtz560
April 30, 2009, 03:45 AM
I'm thinking about getting this scope for pellet shooting and range shooting (w/ ar-15). But I noticed that it doesn't have an adjustable objective. Does anyone know if this will be a problem?

Pellet shooting would be somewhere between 10-40 yards

whereas range shooting w/ my ar-15 would be more in the range of 50+

For those who do pellet shooting.. is the reticule going to be out of focus? Is a scope that's made for real rifles going to work perfectly well for short-range pellet shooting as well?

If you enjoyed reading about "nikon prostaff 3-9 for pellet?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
rcmodel
April 30, 2009, 12:08 PM
No.

Parallax is set for 100 - 150 yards on a hi-power rifle scope.

Focus only begins to get clear at 20+ yards or more at the higher power settings.

An air rifle scope with AO can be adjusted down to be parallax free & in focus as close as just a few feet.

The other thing is, air rifle scopes are built to withstand the two-way recoil impulse of a spring-piston air rifle. (Backward recoil as the piston flys foreward, frontward recoil as the piston slams into the front of the receiver.)

Hi-power rifle scopes have the lens braced to only withstand recoil in the normal direction.

As for using one scope for two rifles?
You would have to sight it in again every time you switched it back & forth.
You would be much better off getting a rifle scope for the rifle, and an air rifle scope for the air rifle, and once sighted in, leaving them alone.

rc

Fred Fuller
May 1, 2009, 04:56 PM
One more vote for getting a scope made specifically for air guns strictly for the air rifle, and something else for the other rifle.

Or one proven to work on .50BMG rifles. :D Both are pretty hard on scopes for the same reason- whiplash recoil. In air guns from the piston, in .50s from the muzzle brakes. It doesn't take a lot of power for an airgun scope, and parallax should be set up properly for appropriate ranges.

hth,

lpl

If you enjoyed reading about "nikon prostaff 3-9 for pellet?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!