M1 Garand not chambering new rounds

PDA






WillDe83
May 10, 2009, 04:08 PM
guess i should have pasted this question here instead...

Hello,

I am new to the forums. I purchased an M1 Garand about a month ago and I went out shooting with it the other day and it would not chamber a new round after each shot (had to pull back on the bolt each time to get a round chambered). I cleaned and lubed the weapon before I went out; not sure what is casuing this, except maybe a bent operating rod? Not sure. What would be wrong with my M1. Any help would be greatly appreciated. Thank You

Will
If you enjoyed reading about "M1 Garand not chambering new rounds" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
krs
May 10, 2009, 04:56 PM
I see you're getting answers all over the place.
Riss
May 10, 2009, 09:50 PM
So is it ejecting ? Or just not chambering ?
loadedround
May 10, 2009, 10:31 PM
Possibly a weak op rod spring or old ammo.
WillDe83
May 10, 2009, 10:33 PM
the spent rounds are ejecting. just not chambering the unspent rounds.
Badger Arms
May 10, 2009, 10:41 PM
Sounds like short-cycling. Bent op rod, gas plug not tight, gas piston too loose a fit, light ammo (Garand likes full-power loads). Wrong bullet weight, sticky chamber. Can't think of anything else off the top of my head.
Riss
May 10, 2009, 11:53 PM
Best option is to check around for a Garand nut (collector) locally. See if he may have the timing gauge or even look it over for you.
PCGS65
May 11, 2009, 01:15 PM
If it ejects correctly it probably not the gas cylinder or OP rod. Change the OP rod spring first. It's the cheapest part. Local gun shows should have them plus they're all over the net too. 8-10 bucks I think.
NC-Mike
May 13, 2009, 08:07 AM
guess i should have pasted this question here instead...

Hello,

I am new to the forums. I purchased an M1 Garand about a month ago and I went out shooting with it the other day and it would not chamber a new round after each shot (had to pull back on the bolt each time to get a round chambered). I cleaned and lubed the weapon before I went out; not sure what is casuing this, except maybe a bent operating rod? Not sure. What would be wrong with my M1. Any help would be greatly appreciated. Thank You

Will


There are a lot of knowledgeable people who love to help with these kind of problems on the CMP forum.


http://www.odcmp.org/new_forum/


You may find your answer by browsing the "Ask Each Other" forum
If you enjoyed reading about "M1 Garand not chambering new rounds" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!