Parts for a Texan Single-Stage Press


PDA






Spot
May 18, 2009, 02:27 AM
I acquired a Texan Single-Stage Press about a year ago, and am wondering on just how interchangeable it is to other single-stage presses. This one is a "C" type. The toggle pin is missing.

As the local pawn shop is charging $30/box of 8mm Mauser 170 gr, I'm going back to reloading.

If you enjoyed reading about "Parts for a Texan Single-Stage Press" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Sunray
May 18, 2009, 04:32 AM
You won't find Texan parts, but you can measure the hole and put in a suitably sized bolt and nut with a washer(easiest fix) or a piece of bar stock. Likely about 3/8", but I'm guessing. As long as it uses 7/8-14 dies, you're all set.

If you enjoyed reading about "Parts for a Texan Single-Stage Press" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!