help with my smith's rear end

PDA






ROBBY.1911
May 31, 2009, 04:05 PM
i have a smith&wesson model 13-2, .357 magnum, 3" barrel. what is it, a square butt or round butt and how do you tell?:evil:
If you enjoyed reading about "help with my smith's rear end" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
rcmodel
May 31, 2009, 04:13 PM
http://www.grips4guns.com/revolver/smithwesson/smithwesson.html

rc
Oro
May 31, 2009, 04:17 PM
Yep, look there and take off the grips if it has big wrap-around rubber ones.

If it is a factory barrel (not a modified one), it SHOULD be a round butt.
Oyeboten
May 31, 2009, 07:35 PM
Yup...if Factory 3 inch Barrel, then would be a Round Butt.


4 inch Barrel ones were Square Butts.


Possibly some Special Order 13s could be otherwise.


Personally, I think they should have offered any variation a person could want, of Barrel Lengths from 2 to 10-1/2 inches, and in either Butt syle, and with Target Sights as an option.
Radagast
May 31, 2009, 11:02 PM
They did offer target sights as an option. It was called the model 19. :P
steveracer
May 31, 2009, 11:27 PM
They made a few 4" guns with round butts. I have seen a lettered one. 13-2, four inch tube, round butt.
Steve
If you enjoyed reading about "help with my smith's rear end" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!