I understand that the same Garand clips that work for 30.06 cartridge will work for the .308 as well. Is that correct?
If you enjoyed reading about "Question: Garand Clips" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
December 26, 2002, 10:14 AM
Yes, they will.
Now to improve function a Garand that has been modified to fire the .308 should have a magazine block in back of the mag well so the clip is not seated too far back.
As far as the clip it's slelf no change is needed.
December 26, 2002, 10:36 AM
I'm certainly no expert but the Garand "clips" are called "enblocs" and as Rusty indicated, they will hold the .308 rounds. It's certainly a cheaper way to shoot the Garand. Those 30.06 rounds are getting expensive!!
Glad to be aboard the new forum and seeing so familiary "faces".
December 26, 2002, 05:04 PM
Same clip is used for both rounds.
The magazine block that is installed in some Garands that have been converted to 7.62 NATO/.308 are to prevent the inadvertant loading of 30-06 ammo. The enbloc clips only fit in the magazine in one location, they wont lock into the rifle if not positioned properly. Actually they may not even enter the magazine well if not located properly.
Wait a minute....
OK I'm back. I just pulled one of my Garands out of the safe and tried to put a clip of 308 ammo in any way but right. It's a no-go on that one. The mag block is purely to prevent loading 30-06 in a 308 chambered rifle.
Hope this helps.
BTW, the mag block goes in the front of the mag well, not the back.
Don in Ohio
December 26, 2002, 07:32 PM
Just a note to say thanks to ya'll for your help! Happy Holidays!
December 26, 2002, 09:02 PM
this is one case where the item really is a "clip" and not a "magazine".