[oldreloader]

Where can I find a new lid for a uniflow powder measure or what other lid will fit it??

[CSA 357]

Try a lid off of a spray paint can, i think i have done it?

[loadedround]

In the morning call or email RCBS Customer Service, I'm sure that they will send you a new one n/c especially if you broke or lost your old one. 1-800-533-5000 or www.rcbs.com ;)

[Landric]

I bought a used Uniflow that came with a cracked lid. I e-mailed RCBS to inquire if they would sell me a new one. They sent me one for free.

[41 Mag]

+3 on the spray can lids. That is all I use anymore for all three of mine. You might try a couple for fit, but once you find the right size they will fit snug enough to stay on great. Also good for sticking tape or labels on for identifying the powder inside the measure.

[dogrunner]

Be aware that there's at least two diff. sizes..........I have both.....one an oldie from the '60's with a metal cap, the second a newer moder that had a green plastic cap when I got it...........broke that one by dropping it on a cement floor & RCBS sent another gratis............great folks to deal with!

The cap they sent is a plastic 'cup' type.

[frankt]

The upside down cap from any Hodgdon powder bottle works fine.

[armoredman]

RCBS customer service is great - call them.

[dubbleA]

Try doing this...... Drill a 1/8" hole in the cap and one in the very top of the resivoir, thread a piece of 1/8" nylon cord about 2-3 inches long through the holes and then use a lighter/flame to melt a ball on each end.This will always keep the cap attached and will prevent it from getting lost or dropped. I have done this to the three I have years ago and havent looked back.;)