[At84]

EXTRACTOR problems. Can any one steer me to a source for the correct parts for my Swiss AT84S 9mm pistol or a gunsmith that has experience with this gun? Photo of gun attached.

[romulus]

It's a clone of the venerable CZ-75. A good smith that works on CZ's will have no problem replacing the extractor. If there are dimensional differences in the parts, I would then check Tanfoglio parts, an Italian clone of the CZ - hey they're in the same neighborhood as the Swiss. The Tanfoglio clone is sold in the US under the European American Armory nameplate as the Witness. EAA might be a potential parts source for your gun, if not CZ-USA.

[dfariswheel]

Like the majority of CZ-75 "clones" the AT-84 series guns were assembled using Tanfoglio supplied parts.

The Swiss produced AT guns had a very high quality of fit and finish.

As above, the American importer of the Tanfoglio guns is European American Arms, (EAA). They sell all parts for the TZ/TA/EA/Springfield P9, AT, and EAA marked guns.

Just check their web site, or give them a call and tell them what model of AT gun you have.

Brownell's does, or did sell many EAA parts.