[rbernie]

Can I use a 20ga Auto5 buttstock or forearm on a Remington Model 11 20ga?

[Jim K]

I think so, but wouldn't want to swear to it. I would order the A5 stock then do some careful checking without doing anything to it. That way if it won't fit, you can return it.

Jim

[Chawbaccer]

Check with Numrich and see if they are selling the same stock for both guns.

[rbernie]

I tried that - they are not.

[Mac's]

Well, this isn't exactly an answer to your question but it's not too far off the subject!

I just did a total refinish on a Remington Model 11 12 guage. This one needed a complete new stock due to the old one being cracked, broken off, etc. I located one for a good price from Macon Gunstocks. I supplied them with the tang measurements because there are several different models of the Model 11. They sent me a full front and rear set. The wood was pretty nice but the fit was absolutely horrible! Yes, I realize that it had to be fitted but this thing had stuff like the barrel channel in the forearm being cut off center, the mag tube holes thru the forearm were cut out of line to each other, the bottom tang slot in the buttstock was just scratched into the wood, the upper tang slot was cut way to deep, etc. If you decide to get a new stock, beware of Macon Gun Stocks! Keep yer powder dry, Mac.
Tuff-Gun Finishes. The Name Says It All.
Mac's Shootin' Irons
http://www.shootiniron.com

[floatingblue]

Hi, guys. In this same vein, I'm wondering if the B Square scope mounts for the A5 will fit the Model 11. I e-mailed B Square over a week ago and have yet to hear anything. Of course, if anyone has a definitive answer to rbernie's question, that would be nice to know, too.

James

[gb6491]

Can I use a 20ga Auto5 buttstock or forearm on a Remington Model 11 20ga?
Remembered seeing this (it might be of some help): http://www.thefiringline.com/forums/showthread.php?t=345958
Regards,
Greg

[rbernie]

Excellent - thanks. :)