[billbuchholz]

Can someone help with 100-125 gr hp loads for the 7.62x25?
Thanks

[R.W.Dale]

IN my opinion that's far too much bullet for x25 without getting into the subsonic side of reloading

[NCsmitty]

I'm not sure what would constitute a good load in a carbine, but when I had a CZ-52, I used the half jacketed 100gr Speer Plinker with a stiff load of Unique with good results.
In a carbine, I would think a bit slower burn powder like AA-9 or AA-7, might be a better choice. The relatively small case capacity does create a problem for slower powders though.
You may need to email a powder distributor to get data for your endeavor.


NCsmitty

[zxcvbob]

115 grain cast bullet (like Magnus #203) and about 7 grains of Power Pistol. Or 9 grains of #7. Or about 9.5 grains of 2400.

I think 110 grain hollow-point charges should be about the same.