looking for a tool

PDA






BlackNet
September 25, 2009, 05:56 PM
Sometime ago I saw a photo of a barrel jig for the rear pin that goes between the ramrod hole and the barrel. It used 2 sizes of angle iron with pre drilled holes in the side. Does anyone have a photo of this tool or know where I can get one of these at?

Ed
If you enjoyed reading about "looking for a tool" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
zimmerstutzen
September 25, 2009, 07:58 PM
I think I remember seeing it in a Dixie Gun Works catelogue.

The jig is nice, but if you have access to a drill press it is unecessary, just measure carefully and drill.
BlackNet
September 25, 2009, 08:58 PM
The person I know who wants it knows how to use other things to drill that hole. they were looking for this unit more for novelty type than anything.
Wolfebyte
September 25, 2009, 09:33 PM
was it listed in this tool thread?

http://www.thehighroad.org/showthread.php?t=449766
BlackNet
September 25, 2009, 09:36 PM
I started that thread and no it's not listed there.
If you enjoyed reading about "looking for a tool" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!