[George Hill]

http://www.smith-wesson.com/Services/Engraving/images/M500laser_right.jpg
That is sweet... a custom lazer engraving job from S&W's shop.
Only $2,058.96
That's pretty dang cool... Not sure if it's Two Large cool... but pretty sweet none the less. If had a couple malteze crosses and "WEST COAST CHOPPERS" on it... maybe...

[MiniZ]

Cool, but not 2 grand cool.

[Jason Demond]

That's over a grand for lazer engraving! What a rip off!

[1badmagnum]

pretty gun.
wish I was a millionaire.

[Tamara]

"Wow, somebody's kid doodled on a revolver that was kinda aesthetically-challenged to start with." :uhoh:

[C.R.Sam]

Note to builder...
Don't let your kid play with the electric pencil around your unfinished guns.

Makes em double ugly.

Sam

[355sigfan]

Now can they cut that damn barrel back to 4 or 5 inches so I can carry it when I am in the woods without a sling.
Pat

[SnWnMe]

Is it the laser engraving that costs? Or maybe some other treatment? According to Smith's lit, laser engraving will cost no more than $65.00.

Anyway, if ZZ Top had a mascot revolver, this would be it

[rock jock]

The concept had potential, but the flmaes look cheap. Traditional scolling would have been much better.

[Ky Larry]

Beauty is in the eye of the beholder. If I had $2000 to spend, I think I would look for a very nice old deep blue Python or Anaconda. Hope it shoots well.

[Randy63]

The cost of the "engraving" should be offset by the fact they didn't have to machine the flutes. 2K is WAY too much IMO.

Randy

[Jeeper]

For 2K I can buy a Freedom Arms