Kimber Ultra Disassembly


PDA






rhc
October 3, 2009, 08:24 PM
I bought a Kimber Ultra. I have followed the disassembly instruction using the special tool and have released the slide. It says to push the slide stop out from the right side. It does not push out. Do I need to pry it out from the left side? I would think it should push out from the right side if I push with a hard surface.
Thanks

If you enjoyed reading about "Kimber Ultra Disassembly" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
wilkersk
October 3, 2009, 08:37 PM
watch this video:

http://www.youtube.com/watch?v=oO-7ZEEQF-g

If its hard to start the slide stop out, make sure you're alinging the the notch in the slide with the slide lock tang. You may try pressing the rounded end of the slide stop on the RH side against the plastic end of a screw driver if it is still a little hard to get started out. If you use a tool to pry the slide stop the rest of the way out, be careful not to mar the finish.

wilkersk
October 3, 2009, 08:43 PM
This might even be a better video:

http://www.youtube.com/watch?v=Qz4JTBNTiQc&feature=related

If you enjoyed reading about "Kimber Ultra Disassembly" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!