[cwc5]

Can someone please tell me why, once disassebling for cleaning, I cant get the bolt back into the reciever correctly after I slid it into the reciever over the magazine tube. Any suggestions? I hope I'm explainning this right. the parts just dont seem to slide far enough into the reciever on the magazine tube. Thank you for your time!

[silversport]

reach up underneath by pushing the carrier up (carrier release button)...on the inside right side near the front is a leaf spring...push it in to the right and the carrier will slide back far enough...

incidentally it was this I was trying to do when I pulled the trigger (I had knocked the safety to off) and I apparently knocked the link loose (or something)...I can get the bolt in but I cannot get it to cock...:banghead:
Bill

[Virginian]

Go to www.remington.com and download an owner's manual.

[oneounceload]

You reassemble in the reverse order of disassembly - you had to depress the spring on the right side to remove the bolt assembly - you have to do the same to reinstall. Make sure the wishbone is properly inserted before hand and you replace the piston parts correctly