[ojibweindian]

I have a Yugo M48A that I just adore, and have bought reloading equipment so that I can reload for it.

While at the range yesterday, I noticed several people sighting in their various .270's and .30-06's for deer season. Knowing that case head diameters for the .270, .30-06, and the 8x57 are the same, I asked those guys if I could have their brass; all said yes.

Now I have several hundred rounds of brass in .270 and .30-06 in addition to the the 2 boxes of S&B 8x57. My question is, can I resize the .270 and .30-06 brass to 8x57 dimensions? If so, how is this accomplished?

Thanks in advanced for all help rendered.

[Black Snowman]

I'm guessing your best bet will be to call the various reloading manufaturers and see what equipent and process advice they have. I know RCBS, Redding, and Lee all make dies for converting caliber but on some that are close enough it's just a matter of trimming resizing and trimming again.

I don't have any experiance with the cartridges you're talking about there but I'm guessing the .30-06 is going to be a better choice than the .270 since you won't be stretching the case mouth so much.

Hopefully someone here will have more experiance with it and can give you more specifics.

[Mike Irwin]

Yes.

You'll need a trim to length die, an accurate "bed lathe" type trimmer to give you the final trim length, and a neck turner wouldn't be a bad idea, either, just in case you have to turn the necks to provide the right chamber clearance with a bullet seated.

With the .270 you really don't stretch the case mouth at all. Most of the case mouth goes away when you reset the shoulder and trim to length.

[ojibweindian]

Is it possible to trim the case, put it through an 8x57 sizing die, then trim to a final length?