Burris Zee Ring Insert?


PDA






David Sours
December 10, 2009, 08:49 PM
Ok, got the new scope today along with my Burris Zee Rings. The 30 mm rings came with one set of 0 Inserts and 1 set of 10 Inserts Two +10 and two -10. So this is how I installed the scope and rings with the hope to get 20 MOA. Please tell me if I am wrong. In the scope ring @ the rear I put the +10 at the bottom and the -10 at the top per the directions. Then on the front ring I put the -10 on the bottom and the +10 on the top. Is this correct and am I right in thinking that I will get an additional 20 MOA in elevation?

If so when I bore sight the rifle should I have to move the elevation of the scope down, to get the zero?

Thanks,
David

If you enjoyed reading about "Burris Zee Ring Insert?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
browningguy
December 10, 2009, 09:58 PM
You are correct, as to which way to adjust, no way to know that until you give it a try.

David Sours
December 10, 2009, 10:03 PM
Thanks for the confirmation. Hopefully the wind will lie a little and I am headed to the range tomorrow to zero it in. Then we will know for sure.

Thanks,
David

If you enjoyed reading about "Burris Zee Ring Insert?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!