[rogn]

Got a Browning BL-22 I think years ago in payment for a loan. Pretty gun but it shoots about 18" high around 30 to 50 yds. Would have to put the front sitght in the barrel to lower it enough and a scope hasnt got a chance. Anyone have any good ideas? Havent tried calling Brownig but may give it a try.

[N.Schafer]

If it's shooting high, you need to lower the rear sight or raise the front sight.

[rogn]

Would probably need about an inch and a half of lowering or raising-just havent got it Its really 18" high.

[Chawbaccer]

If you could disassemble it enough you could look through the bore and see if it was bent

[highlander 5]

If the above info is correct you need a front sight that is .200" higher. there is a formula to figure for windage/ height. take the amount in inches that you are hi/low divide by the distance you are shooting at in inches in this case it is 18' divided by 1800" (50 yds) then multiply by barrel length 20". I think your problem that is not sight related.

[rogn]

I think its bent or off center. Rifle originally came from my store and I dont think the fellow abused it. Hight of front sight still wont help my 67 year old abused eyes.