.250 Savage Brass needed


PDA






testar77
January 22, 2010, 06:14 PM
not sure if I should post this in here but I wanted to target the right crowd ;) lookin to swap some brass, I need some .250 Savage Brass and would be willing to swap for some. I have all kinds of different brass. So if you have any let me know what you need and I will take a look.


Thanks, Toby

If you enjoyed reading about ".250 Savage Brass needed" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
the_right_reverend
January 23, 2010, 06:39 PM
http://oncefiredbrass.com/winchester250savagew-w.aspx

if all else fails

use this guy all the time

Jefferson Herb
January 24, 2010, 02:34 AM
If You can't find anything else 22-250 brass would work.The necks might be thin,if careful should'nt split.It's easier to go down than up,but iform 7mm tcu from .223 and do it in one pass. I use imperial sizing wax.

Zeke/PA
January 24, 2010, 01:25 PM
How much do you need?
Graf has it for $ 28.00/50

testar77
January 25, 2010, 12:52 AM
well I was hoping to try and find someone to swap with so I didn't have to buy any, as things are tight these days :o

Zeke/PA
January 25, 2010, 05:18 AM
testar,
How much do you need?

testar77
January 25, 2010, 02:26 PM
Ultimately would like to have 100+ on hand, but will take whatever I can get right now. If you have some to get rid of, let me know what calibers you load for and I will see what brass I have to trade.

If you enjoyed reading about ".250 Savage Brass needed" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!