Redding BR-30 on an LNL


PDA






Walkalong
March 8, 2010, 12:36 PM
I had previously set my Redding 10X measure up to work automatically (http://www.thehighroad.org/showthread.php?t=464088) on my LNL, but I have been working my BR-30 measure manually. Much slower.

I finally got around to setting up the BR-30. I made the parts I needed yesterday, and set it up today.

When I set up the 10X before there a good bit of trial and error going on, since I was starting completely from scratch.

This time I didn't have to make all the parts, and had some measurements to go by, making things easier. The most critical measurements were the angle of the lift arm and the distance from center the pivot needed to be on the lift arm.

http://www.thehighroad.org/attachment.php?attachmentid=117250&stc=1&d=1268069750

If you enjoyed reading about "Redding BR-30 on an LNL" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
If you enjoyed reading about "Redding BR-30 on an LNL" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!