New toy available from LEE


PDA






tackstrp
April 3, 2010, 10:13 AM
Lee Bulge Buster Base Sizing Kit (380 Auto, 40 S&W, 45 http://www.midwayusa.com/viewProduct/?productnumber=882261


looks worth while

If you enjoyed reading about "New toy available from LEE" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
rcmodel
April 3, 2010, 11:46 AM
A discussion here:
http://www.thehighroad.org/showthread.php?t=502850&highlight=Lee+Bulge+Buster

rc

tackstrp
April 3, 2010, 08:42 PM
thanks RC ordered the gadget from midway and a lee sizing die. . almost as cheap to just order the three die set.

tackstrp
April 4, 2010, 12:09 PM
ran about 50 reloads thru my new Lee Factory taper crimp die. Could feel all of them getting somoothed out. Then tested all on a Wilson case gauge for headspace. Had two that would not seat fully. I plan on saving those and will remove powder primer etc and test on the new lee gadget when it comes in . Golly bum . if it works as i hope, will do all my cases. so would be sized and the bulge taken out. Or so i hoope . Will find out .

Thanks for the assistance.

ArchAngelCD
April 5, 2010, 03:13 AM
I've heard that is a good tool, just remember, the brass might be weaker because of the original bulge and will probably have a shorter reloading life span...

Beelzy
April 5, 2010, 01:49 PM
Wow! I predicted the future in that other thread about the .380......LOL!!!

tackstrp
April 8, 2010, 02:40 PM
i ran over 500 resized and deprimed tumbled 380 auto brass through the lee bulge buster. Most can push with finger. rest need a bump from the primer arm to push.

Amazed how many need a bump. sure will have fewer failure to fire or feed.

If you enjoyed reading about "New toy available from LEE" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!