Finishing an 80% AK Receiver


PDA






wcoats
April 27, 2010, 08:11 PM
So, I'm looking to finish an 80% receiver. I am looking for some where that shows the steps involved in finishing one. I have found tons of videos and pictures of people bending them, but haven't found some where that describes the steps. Such as how far apart the bends need to be, and exactly where the rails for the carrier need to be welded.

Thanks for any info

If you enjoyed reading about "Finishing an 80% AK Receiver" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
MartinS
April 28, 2010, 10:33 AM
Have you seen this one yet?

http://www.akfiles.com/forums/showthread.php?t=61255

If you enjoyed reading about "Finishing an 80% AK Receiver" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!