CDNN has stocks that fit E & I frame Colts. I'm assuming that you have either a 38 or a 22 OMM because this thread is in the revolver category and as such would be, most probably, an "E" frame.
July 17, 2010, 03:45 PM
Stocks made for the Python will also fit Colt's Officers Model Match/Target/ etc. revolvers as well as older Army Special and Official Police guns. ;)
July 17, 2010, 04:18 PM
Like these at Eagle (http://www.eaglegrips.com/guns/Colt-Python-Rosewood-Heritage-Gr.html) grips.
July 17, 2010, 09:25 PM
A lot of Colt owners like the Hogue Mono-Grip.
These are available in rubber, or in fancy woods with options like with or without finger grooves and fancy caps on the butt.
These are very good looking and feeling grips, and due to the mounting system, are the most solid grips.
July 18, 2010, 07:21 AM
I second the Hogue. I put Hogue wood grips on both my trooper mk III and my 357. They fit the hand much nicer than the stock colt grips that flare out at the base.
If you enjoyed reading about "replacement stocks sought for Colt" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!