Case trimming question


PDA






KFDiesel
August 15, 2010, 10:18 AM
I trimmed back some 22-250 brass and around the case neck they are "sharp", actually the trimmed brass has kind of a Ridge around it. Should I just use a metal file and do the best I can?

If you enjoyed reading about "Case trimming question" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Blackrock
August 15, 2010, 10:34 AM
Now you use an inside/outside chamfering tool on the case mouth. Just easy does it to remove the burrs.

Sam1911
August 15, 2010, 11:41 AM
This is the kind of deburring tool I use, though there are several designs.

http://media.midwayusa.com/ProductImages/Large/364181.jpg

Midway and others carry them for $10-15.

loadedround
August 15, 2010, 06:23 PM
I've used the same tool used by Sam1911 for years and it does any excellent job. They are made by RCBS and any gun shop selling reloading equipment will have one. About 15.00.

If you enjoyed reading about "Case trimming question" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!