CDNN scope: UTC 1-4X 28MM?


PDA






dogsoldier0513
September 6, 2010, 02:12 PM
Has anyone actually TRIED one of these? Any personal experience is appreciated. TIA

If you enjoyed reading about "CDNN scope: UTC 1-4X 28MM?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
wally
September 6, 2010, 06:47 PM
Assuming you mean UTG, I've got one and while its no Millet DMS, it is smaller and very serviceable.

However it does seem to have some noticeable POA/POI shift going from 1X to 4X so I zeroed at 4X and then shot a group at 1X and dialed in half the shift which makes the difference negligible for my purposes (shooting steel plates) I like 1X for the fast shots at the larger plated and 4X for the smaller plates or at longer ranges.

I've only used mine on a 5.56x45 so I won't make any claims about durability, but so far so good for me. The turret setup is really pretty nice, but I never tried shooting the box adjustments and frankly think these type of turrets are overkill on a 1x4 scope where I'm going to zero using 4X at the "point blank" range and then use the mil dots for any holdover/windage.

If you can afford better the Millet DMS at 2X+ or the Trijicon Accupoint at 6X the cost are better.

If you enjoyed reading about "CDNN scope: UTC 1-4X 28MM?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!