Advantage Arms Glock detail strip


PDA






matai
September 7, 2010, 12:58 AM
Hey, anybody know how to detail strip an Advantage Arms Glock .22lr conversion slide? I've emailed AA but haven't heard back.

After 20 or 30 thousand rounds it's getting gritty inside.

Thanks!

If you enjoyed reading about "Advantage Arms Glock detail strip" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Hk Dan
September 7, 2010, 10:54 AM
It's straight forward, just make sure you get the little ejector tab lined up properly when ya reassemble.

gofastman
September 7, 2010, 01:27 PM
It strips just like a glock with the exception of the extractor retainer pin, watch out for the tiny spring that places tension on the extractor too.
that spring can bind up upon reinstallation so watch out for that.


this may help you too.
http://glocktalk.com/forums/showthread.php?t=1251184

matai
September 8, 2010, 09:51 PM
Thank for all the help.

One more question, how do you guys clean out the hole where the ejector goes in?? I can shoot CLP up in it and it comes out super dirty. I'll also clean the extractor, put it in and it will come out dirty.

Any ideas?

gofastman
September 8, 2010, 10:45 PM
I would think an aerosol gun cleaner like Gun Scrubber would do the trick.

I bet you could also blast it with CLP and wait a few hours for it so loosen stuff up then repeat until its clean. CLP works great, but it needs more dwell time than other cleaners.

If you enjoyed reading about "Advantage Arms Glock detail strip" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!