Hennings's grips for Witness elite match


PDA






greyling22
September 25, 2010, 03:52 PM
I searched all over the internet and couldn't come up with any pictures of Hennings's grips on a gun, But I bought them anyway and now I am posting the pictures. The regular grip width measured out 1.35 inches, and Henning's grips reduced it to 1.2 inches. They fit on nice and tight and the thinner grip is super, I just wish they were longer. they expose some nooks and crannies the factory grips covered up. I also with they were made of plastic and cost $40. But all in all, I'm pleased, and if you can get ahold of henning he's great to talk to.

PS: you need to buy the Henning's torx screws. the factory screw heads are too big for Hennings's holes. Or you can try turning your heads down or going to the hardware store.

If you enjoyed reading about "Hennings's grips for Witness elite match" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
greyling22
September 25, 2010, 04:22 PM
Mods, I realized I put this in the wrong forum. could it be moved to autoloaders?

If you enjoyed reading about "Hennings's grips for Witness elite match" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!