[Daguerre]

Hey, before taking the plunge on a stainless Kahr, I just have to ask if the polymer Kahrs are finally up to snuff. For quite a while there it seemed as though most of the problems with Kahrs were with polymer framed guns... I'm hoping that's been resolved. Anyone know much about this? Thanks guys. Still trying to decide between K40, MK9, or PM9.... hmmmmmmmmmm.

[ajacobs]

I have 4 kahrs one is a p9 with a ya serial number prefix. It has been flawless. I belive from what I have read that all the bugs are worked out.

[El Tejon]

Have several P9s. No problems. Like the little buggers (get it) a lot.

[Coot]

The PM9 has a spring within a spring, held in place on the guide rod assembly. The first time I fired mine, the small end piece on the rod followed a bullet towards the target and was lost. A phone call to Kahr's excellent customer service and a replacement assembly was in my hands 2 days later.

I've had no other problems with mine- not even one failure to feed/fire/eject in 500 rounds. I carry it loaded with Federal EFMJ.