Blackhawk Serpa Level III Problems


PDA






dovedescending
October 2, 2010, 03:19 PM
My brother, who is in the academy :D is having difficulty with his Serpa Level III retention holster. It is department issued, for a Sig 220. It likes to hold onto that gun like it was Level VIII or something :/

It seems like the judicious use of a dremel or sandpaper might loosen up the tolerances so that the holster fits the gun, but he hesitates
because he'd rather not "tamper" with a department issued piece of equipment.

Other than repeatedly drawing and reholstering thE weapon, what can he do to loosen up the holster so he doesn't have to wrestl his weapon?

If you enjoyed reading about "Blackhawk Serpa Level III Problems" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
dovedescending
October 3, 2010, 09:52 PM
Bump? Bump bump.

AWorthyOpponent
October 5, 2010, 01:49 PM
There is a screw on the side that he can adjust to increase or reduce the tension.

dovedescending
October 5, 2010, 01:52 PM
:) We're not idiots. We tried that already.

swinokur
October 5, 2010, 03:26 PM
exchange it.

If you enjoyed reading about "Blackhawk Serpa Level III Problems" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!