Alcan AL5 and 40S&W


PDA






unobvs
December 6, 2010, 12:51 PM
I have looked for some time and have been unable to locate any load data for using Alcan's AL5 powder with 150-155 gr. jacketed bullets.

Does anyone here have such experience?

Thanks for any help.

If you enjoyed reading about "Alcan AL5 and 40S&W" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Ateam-3
December 6, 2010, 02:16 PM
I do not think you will find any such data. AL-5 was discontinued probably 30+ years ago and the 40 S&W was not developed until 1990 or so. As such, I do not think any loads for the 40 would have been tested or developed using that powder.

rcmodel
December 6, 2010, 02:40 PM
+1
Alcan powder was dead & gone long before the .40 S&W was invented.

AL-5 was primarily a shotgun powder.
Burning rate falls between Universal Clays and AA #5, so it would probably work in .40 S&W if you could find any pressure tested .40 load data. But you can't.

The old Speer #6 manual listed it in a lot of calibers, but it was published way before the .40 S&W was invented.

They do show .38 Super & .44 Mag loads that are very close to the Unique loads.
However, AL #5 is slightly faster burning then Unique so DO NOT use Unique .40 S&W Max loads with AL #5.

And you do so AT YOUR OWN RISK!!
If you blow up, don't blame me!


PS: I should have mentioned to check for deterioration in powder that old.

Smell it, and if it smells like acid, and not like solvent?
Dump it on the lawn. It is nitrogen fertilizer now.

rc

If you enjoyed reading about "Alcan AL5 and 40S&W" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!