Rounded BHP Trigger Lever


PDA






Random Discharge
December 27, 2003, 12:04 PM
Some time ago I had a gunsmith remove the magazine disconnect safety and install a wide combat trigger on my BHP. He also rounded the trigger and sear lever contact edges to improve the trigger pull. Soon after the trigger failed to engage the sear lever-I suspect because the two rounded surfaces simply slipped past each other. He replaced the sear lever and left it alone, but the trigger lever remains rounded to this day. It's had a few hundred rounds through it since, but I've always wondered if this would become a reliability issue. Any BHP experts out there with an opinion on whether I should replace the trigger lever?

I've attached a picture to show what I'm writing about - poor quality, but good enough to get the point across.

Thanks,
R.D.

If you enjoyed reading about "Rounded BHP Trigger Lever" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
George Hill
December 27, 2003, 12:45 PM
If Stephen A. Camp doesn't see this thread, send him a Private Message.
He wrote the book on the HP.

C. H. Luke
December 27, 2003, 02:25 PM
Run it by www.fnhipower.com

If you enjoyed reading about "Rounded BHP Trigger Lever" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!