[bloominonion]

I have a Lyman S-T turret press, and it doesn't have a primer catcher. i was debating about just making one, but I need ideas/pictures. If anyone has this press, or one similar, please let me know what you did for a primer catcher.

I can't deal with spilling primers all over the stinkin floor all day long, especially now that my new press has a primer catcher.

Here is a pic of it.
http://farm6.static.flickr.com/5219/5459725965_936546c294_z.jpg

[Lee Roder]

I use the catcher which came with my SparT. It "grips" the stem of the press just below the attachment point for the primer arm.

http://i536.photobucket.com/albums/ff325/x97541x/SparT-primercatcher.jpg

Probably could improvise one if you are crafty, but a bed sheet spread on the floor beneath the press is probably simpler and also works well to catch the crap.

HTH

[skselby]

Wonder if the primer catcher (http://www.midwayusa.com/viewproduct/?productnumber=708809) for the crusher and t-mag would work?

I have one on my old t-mag -- looks like the picture in the post above, but in black.

[bloominonion]

I was debating about making my own out of kydex. I have a few square feet of it lying around, but if a new catcher like that is ~$10, I might just buy one.

LeeRoder, would you ming measuring the inside dimension of where it goes around the press body?

[Zonker]

Call Lyman, they may well send you one for free.

[Lee Roder]

bloominonion, the opening is horseshoe shaped, with a narrow entrance measuring approximately 1.4" across widening to 1.5". It shoves onto the press OK.

[32dgrz]

I was told that catcher for the current press will work. Of course this was after I spent too much for an original one on ebay

[Sunray]

It's an old press. I'd make a catcher out of a margarine tub and duct tape.

[bloominonion]

It's an old press. I'd make a catcher out of a margarine tub and duct tape.
I will make one out of kydex if the dimensions don't match up. I have some extra floating around from making some CCW holsters.