well i see at VTI they have a 1860 3" snub nose barrel in 44 cal in pietta. I was told in the past though it has been some time that the barrel would fit. i may try that.
April 19, 2011, 10:02 PM
You'll have to get another cylinder, too then. the Army is a .44. Try a .36 Navy barrel.
April 19, 2011, 10:05 PM
This one should work...
A345/CFSH36 Pietta Confederate Sheriff Barrel (Round) .36cal with Sight & Loading Lever Retainer (1851 Navy) Check Stock US$125.00
April 20, 2011, 12:08 AM
mine is a 44 cal. the cyklinder i have will work. the reason i wanted to go to 36 is the original navys where 36 and not 44. but i can get a 1860 44 barrel and just convert. but it will all take time to many bills to pay right now. lol
April 20, 2011, 12:17 AM
The links I gave you were for the Pietta, anyways. I REALLY shouldn't post when I'm tired. VTI Gunparts has the widest selection of Uberti parts out there.
April 20, 2011, 12:24 AM
yeah l ike vti. they have been good to me so far. there was a few times i didn't get what i ordered but it was out of stock. but they called me.
April 20, 2011, 12:26 AM
Yep, good folks. I been doing buisness with them since they started.
April 20, 2011, 12:31 AM
i ordered a 1851 from emf years ago. i got it in 44 only to realize later that the orginals in the 1800's were 36 cal. but i don't mind the 44 because i can put a 1860 barrel on it. this hole thing started lol becausr i've been looking into shorter barrel versions. 3 inch to 3 1/2. i've cut my 51 barrel down to 3 inches and had it lathed for squaring but putting sight has always been the problem. tired of working on it lol thought screw it just buy another barrel.
April 20, 2011, 12:49 AM
If you enjoyed reading about "uberti 1862 police trapper barrel" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!