Has the Beretta PX4 trigger sting issue been resolved?


PDA






Paincakesx
May 24, 2011, 06:20 AM
Seriously considering this weapon, but I've read some horror stories about trigger sting issues.

Most of these stories come from a few years ago though, so I was wondering if this issue has since been resolved, or if it still ongoing.

Thanks!

If you enjoyed reading about "Has the Beretta PX4 trigger sting issue been resolved?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
RX-178
May 24, 2011, 09:54 AM
I'm not sure what you're referring to, to be honest.

I've fired them in 9mm and .40, although I don't own one. I've never had any kind of discomfort in my trigger finger from it.

beretta/ak
May 24, 2011, 10:07 AM
I have the px45. Living in Alaska and shooting in the winter I felt some trigger sting when the gun was new. I wanna say around 500 rounds the sting went away.

Lonestar49
May 24, 2011, 12:11 PM
...

For the very most part yes..

My original Px4 40, bought NIB Jan 07, (and most T/S cases, 98%, were in the 40cal models of DA/SA)

In just over 1 year, after 2000 rounds it began to sting, namely during colder temps but come summer, my gun now had nearly 4000 rounds and it became 2 cold mags worth (20) shots or a tad more to finally warm up the gun enough for whatever it was that was causing the trigger sting to go away.. My bet is "flex" finally kicked in, via heat, and the T/S stopped. But cold and rigid guns, back then, were not possible to continue firing past 20 rounds unless gloves were worn.

After 4000 rounds thru 6450 flawless rounds, it was full time, any time, all the time and I, finally, sent it back, went thru a 6 month, 3 week, pure headache, to finally demand send back my original gun or send me a NIB replacement.. "Small claims court" will be next :fire:

They did finally did. And I did notice some changes, one that could be seen, the other that could be felt (trigger SA engagement)

First gun was a PY 125** and the NIB replacement was PY383** and now, with over 3000 flawless rounds over 3yrs and thru cold temps, hot temps, any temp/weather, it has not shown any trigger sting..

So, I think it is fairly safe to say, you will not have any problems regarding trigger sting but I must mention that the triggers very thin and sharp end/s can, if one over-places one's trigger finger, too much, one can get a felt pinch, which can be easily corrected by not putting in quite so much trigger finger/application/pull..

Great guns, soft shooters, balanced, with the rotating barrel effect..

http://i217.photobucket.com/albums/cc306/Lonestar49/Picture390.jpg

Accuracy is spot on with them.. with or without laser

OMMV


Ls

If you enjoyed reading about "Has the Beretta PX4 trigger sting issue been resolved?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!