I have three owb holsters for the Kahr. Two of the holsters were quite expensive, over a hundred each. The third holster was $25 and it is my favorite of the three, the Don Hume JIT. Get it. You'll not want another holster.
August 4, 2011, 05:34 PM
The OP's list does pretty much describe a Don Hume 721.
August 20, 2011, 12:15 AM
High Noon could be worth looking at.
August 24, 2012, 01:36 PM
Does anyone know if Don Hume makes a holster for the CM9 with the CT laserguard?
edit: just saw that this thread is from August LAST year... oops *bump* i guess.. OP: what did you end up getting?
The Contour Belt Slide is the ideal holster for those who want more concealment than a paddle, but do not want to go inside the waistband. The contour cut, with the molding on the exterior of the holster and a flatter, slightly curved interior pulls the holster more tightly into the body than traditional pancake styles. An open bottom means that similar frame size weapons, such as all Glock 9mm/.40/.357 Sig caliber pistols, 1911 frames, Springfield XD's, etc. will fit the same holster. The dual belt slots pull the weapon in close to the body, while the angle of the weapon is a 15 degree FBI cant, perfectly suited for just behind the hip wear on the strong side. It is available for most auto-pistols, as well as many small revolvers.
August 24, 2012, 07:46 PM
Too bad you spec'd leather. Galco makes a M7X Matrix in polymer for $27 which is very nice...it is like a polymer Alessi CQC/s