45 acp - 45 long colt projectile


PDA






jef2015
August 28, 2011, 08:19 PM
Another question for you guys...
I bought a used press which came with quite a few bullets and brass in different calibers. Many of the bullets were mixed together. I have separated most of them into respective boxes by caliber, type and weight.
My question, what are the dimension differences between 45 acp and 45 long colt. I understand some 45 long colt are a little heavier than 45 acp. 45 acp load data is usually for a max of 230 grain bullet so the heavier bullets I put aside. The diameter looks to be the same of .452 for lead bullets. Can you reload 45 long colt bullets that are 230 grain or less in 45 acp brass? What other differences should I look for? For now I don't have a 45 long colt to load for.

Thanks in advance for helping the newbie out...

If you enjoyed reading about "45 acp - 45 long colt projectile" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Vartarg
August 28, 2011, 08:23 PM
Your gun won't know the difference......

Mal H
August 28, 2011, 08:30 PM
What other differences should I look for?
The .45 Colt bullets may or may not have a cannelure. If they do, don't feel like you need to crimp at it for your ACP rounds. Use the proper OAL as your guide, and you may have to do some guessing as to what is proper since the bullet types can be quite different even for similar weight bullets. The idea is to have an equal amount of the bullet base inside the case for each type. You may have some feed ramp issues as well with some of the .45 Colt bullets.

Otherwise, just use conservative loads to start with, and you shouldn't have a problem.

Hondo 60
August 28, 2011, 09:52 PM
Mal H gave the best answer I could think of. ^^^^^^

Master Blaster
August 29, 2011, 05:44 PM
Measure the bullets first with a set of calipers or a micrometer. Some older .45 colt guns had a .454 groove diameter and those bullets may be for an older .45 colt and could be sized .454 or even .455, so you could create a dangerous overpressure situation in your 45 acp. If they measure .452 or .451 you are good to go so long as you use the correct data for the bullet weight.

Paladin38-40
August 29, 2011, 07:44 PM
200 grain cast SWC sized .452 works well in 45 ACP and my Gen 3 .45 Colt (AKA LC). Roll crimp over the shoulder for .45 Colt. 8.5 grains of Unique gives
825 fps in a 4 3/4" barrel. This is a very pleasant plinking load.

If you enjoyed reading about "45 acp - 45 long colt projectile" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!