Cdstang
September 13, 2011, 08:42 PM
I thought I would share my fix for the hornady lock & load ap,where the finished shell drop. When prepping 9mm brass I always had a problem of them going
under the ram. So this was my fix for that problem.
http://i56.tinypic.com/2q36n2w.jpg
http://i54.tinypic.com/mcvjhh.jpg
http://i54.tinypic.com/73f510.jpg
I have a few extras made, send me a pm or email
Thanks
Bobby
Walkalong
September 13, 2011, 08:53 PM
Very nice. Mine does fine with 9MM. Go figure. Did you attach it to the bin bracket so it stays put when you dump the bin?
Cdstang
September 13, 2011, 09:59 PM
For right now I have double sided tape holding it in place. But later on when I get more time I'll drill a hold and put a screw to hold it in place.
GarySTL
September 13, 2011, 11:57 PM
Slightly off topic, how do you like your case feeder? Was talking to a fellow today where I buy some of my supplies and he said he took his off because it was a PITA to adjust.
I'd been considering adding one to my LnL press.
Cdstang
September 14, 2011, 08:10 AM
Well I like mine, it took me a little time to get it setup. And I called hornady and got the new drop tube for the 40s&w. The part number on the shipping list is
#398302
357Shooter
September 14, 2011, 08:23 AM
Good Fix, I've had some 357 & 45ACP do the same, now I have another project today!
Thanks for the post!
