Tempilaq--How Much


PDA






j2crows
September 28, 2011, 02:36 PM
Which of these 3 cases do you think shows the correct amount of Tempilaq?

If you enjoyed reading about "Tempilaq--How Much" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Sport45
September 28, 2011, 10:52 PM
I'd say the middle one. But shouldn't it be on the outside and a across the shoulder?

dave from mesa
September 28, 2011, 11:15 PM
Tempilaq?

Hondo 60
September 28, 2011, 11:47 PM
dave from mesa - it's for annealing - here's a You Tube link to help you understand.
(I didn't know either so I had to google it)

Induction Annealing with Tempilaq

http://www.youtube.com/watch?v=Uasv-Pyxu4g

MEHavey
September 29, 2011, 10:42 AM
I believe 750ᵒF Tempilaq is blue (and would be normally used right inside the neck). What temp is that yellow?

(But) assuming that's 750-ish fluid any of the cases would be fine as you're just looking for melt/color change. (In fact the one on the left would be the most efficient use of the fluid)

If using 475-500ᵒF Tempilaq, it would go on the case body 1/4" below the shoulder.

j2crows
September 30, 2011, 11:28 AM
650 degrees

If you enjoyed reading about "Tempilaq--How Much" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!