Walther P38 Experts wanted


PDA






duelist1954
January 3, 2012, 06:13 PM
I just picked up a 1960 vintage Walther P-38. The frame is marked P-38, but it is alloy. I thought those were called P-1s?

Are P-1s still marked P-38?

I haven't shot it yet...will do so tomorrow. But I have run a couple of magazines full of rounds through the action. I find it very hard to rack the slide back with a round in the chamber. Is this typical?

Thanks!

If you enjoyed reading about "Walther P38 Experts wanted" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
P5 Guy
January 3, 2012, 06:29 PM
One of mine. As you see the re-enforcing pin in the alloy frame and labeled as P38.

PRM
January 3, 2012, 06:32 PM
P1 and P38 are both correct, based on who they were made for. Post war P38s were all stamped P38 up until 1957~1963 (dependent upon source cited). Most collectors will give you the 1957 date. At that time the German military began stamping their guns P1 and using that terminology. Civilian models continued to be called the P38 and stamped as such.

Sight adjustment is with the front sight only. Try and drift the rear sight, you will damage the cover on top of the slide. Don't remove this ~ they are easy to damage and the gun should not require that level of stripping for normal cleaning.

The P38 was designed to shoot the 124 grain FMJ standard velocity round. A lot of shooters are using the 115 grain FMJ Winchester White Box with great results. Stay away from heavier bullets, plus P rounds, or putting heavy spring kits in the weapon.

Late Upgrades: Not a deal breaker ~ but nice to have if you got one with them.

Hex Bolt

The hex bolt was installed to give the locking block something to ride on rather than the aluminum frame. One needs to keep in mind that thousands of these guns were in service for decades prior to the hex bolt and saw no problems. Most in private collections will never be shot enough to manifest a frame wear problem.

Fat Slide

The "fat slide," is identified by the longer battery of serrations that extend forward of the safety lever. More early Walther P38s had problems with cracked slides over frame problems. Walther beefed up the slides to correct that.

A couple of sites to do some good research are:


http://www.waltherforums.com/index.php

http://forums.p38forum.com/forums/index.php

If you enjoyed reading about "Walther P38 Experts wanted" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!